MULTIQUIP Power DCA85USJ2 Operation And Parts Manual page 24

!
Indicates Auxiliary Gage Fault
!
Indicates Fault Warning
!
Indicates Derate or Shutdown Condition Fault
5. Touching the "Enter Button" will redisplay the hidden
fault. Touching the "Enter Button" once again will hide
the fault and return the screen to the single or four
parameter display. NOTE: The fault can only be cleared
by correcting the cause of the fault condition.
1 of x
ENGINE OIL PRESSURE
GAGE NOT RESPONDING
Active Fault Codes
1. During normal operation the single or four parameter
screen will be displayed
125°F
1000 RPM
COOL TEMP ENG RPM
143°F
57 PSI
OIL TEMP
OIL PRES
2. When the PowerView receives a fault code from an
engine control unit the single or four parameter screen
will be replaced with the "Active Fault Codes" message.
1 of x
SPN110 FMI10
HIGH COOLANT TEMP
3. If the word "MORE" appears above the "Arrow Buttons",
there are more active fault codes that may be viewed.
Use the "Arrow Buttons" to scroll to the next "Active
Fault Code".
1 of x
SPN110 FMI10
HIGH COOLANT TEMP
PAGE 24 — DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11)
HIDE
1000 RPM
98%
LOAD RPM ENG RPM
14.2 57 PSI
BATT VOLT
OIL PRES
WARNING
MORE
HIDE
MORE
HIDE
DIAGNOSTIC DISPLAY
4. To acknowledge and "Hide" the fault and return to the
single or four parameter display touch the "Enter
Button".
1 of x
SPN110 FMI10
HIGH COOLANT TEMP
5. The display will return to the single or four parameter
display but the display will contain the "Active Fault"
warning icon. Touching the "Enter Button" will redisplay
the hidden fault.
!
0 1500 3000
1800 RPM
ENG RPM
COOL TEMP!
6. Touching the "Enter Button" once again will hide the
fault and return the screen to the single or four
parameter display.
1 of x
SPN110 FMI10
HIGH COOLANT TEMP
7. The Single or Four parameter screen will display the
fault icon until the fault condition is corrected. NOTE:
Ignoring active fault codes could result in severe engine
damage.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONF G
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
MORE
HIDE
1000 RPM
98%
ENG RPM
LOAD RPM
!
14.2 57 PSI
BATT VOLT OIL PRES
WARNING
MORE
HIDE
1000 RPM
98%
LOAD RPM ENG RPM
14.2 57 PSI
BATT VOLT
OIL PRES
!