MULTIQUIP Power DCA85USJ2 Operation And Parts Manual page 22

2. The language choices will be displayed. Use the
"Arrow" buttons to scroll through the selections and
touch "Enter" to make a selection.
ENGLISH
ESPANOL
FRANCAIS
DEUTSCH
3. Now that you have selected the language, touch the
"Menu" button to return to the main menu display.
Stored Fault Codes
1. Starting at the single or the four engine parameter
display touch the "Menu button".
0 1500 3000
1800 RPM
ENG RPM COOL TEMP
2. The main menu will pop up on the display. Use the
"Arrow Buttons" to scroll through the menu until the
Stored Fault Codes is highlighted.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
3. Once the "Stored Fault Codes" menu item has been
highlighted touch the "Enter Button" to view the "Stored
Fault Codes" (when applicable, consult engine or
transmission manufacturer for SAE J1939 supported
parameters
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
PAGE 22 — DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11)
1000 RPM
98%
LOAD RPM ENG RPM
14.2 57 PSI
BATT VOLT
OIL PRES
G
G
DIAGNOSTIC DISPLAY
4. f the word "MORE" appears above the "Arrow Buttons"
there are more stored fault codes that may be viewed.
Use the "Arrow Buttons" to scroll to the next Stored
Diagnostic Code.).
1 of x
SPN110 FMI10
HIGH COOLANT TEMP
5. Touch the "Menu Button to return to the main menu.
1 of x
SPN110 FMI10
HIGH COOLANT TEMP
6. Touch the "Menu Button" to exit the Main menu and
return to the engine parameter display.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONF G
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
Engine Confi guration Data
1. Starting at the single or four engine parameter display
touch the "Menu Button".
0 1500 3000
1800 RPM
ENG RPM COOL TEMP
MORE
HIDE
MORE
HIDE
1000 RPM
98%
ENG RPM
LOAD RPM
14.2 57 PSI
BATT VOLT OIL PRES
1000 RPM
98%
ENG RPM
LOAD RPM
14.2 57 PSI
BATT VOLT
OIL PRES