MULTIQUIP Power DCA85USJ2 Operation And Parts Manual page 19

First Time Start Up
1. When power is fi rst applied to the diagnostic display,
the "Logo" is displayed.
2. The "Wait to Start" message will be displayed for
engines with a pre-startup sequence. Once the "Wait
to Start" message is no longer displayed the operator
may start the engine. Note: Displays only when SAE
J1939 message is supported by engine manufacture.
3. Once the engine has started the single engine
parameter is displayed.
0
1800 RPM
ENG RPM
Main Menu Navigation
1. Starting at the single or four engine parameter display,
touch "Menu".
0 1500 3000
1800 RPM
ENG RPM COOL TEMP
DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11) — PAGE 19
WAIT TO
START
PREHEAT
3000
1500
COOL TEMP
1000 RPM
98%
ENG RPM
LOAD RPM
14.2 57 PSI
BATT VOLT OIL PRES
DIAGNOSTIC DISPLAY
2. The first seven items of the "Main Menu" will be
displayed. Touching the "Arrow Buttons" will scroll
through the menu selection.
GO TO 1-UP DISPLAY
LANGUAGES
STORED CODES
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
3. Touching the right arrow button will scroll down to reveal
the last items of "Main Menu" screen highlighting the
next item down.
ADJUST BACKLIGHT
ADJUST CONTRAST
UTILITIES
4. Touch the Arrows" to scroll to the desired menu item
or touch "Menu" to exit the Main menu and return to
the engine parameter display.
0 3000
1500
1800 RPM
COOL TEMP
ENG RPM
Selecting a Language
1. Starting at the main menu display use the "Arrows to
scroll to the "Language" menu and once highlighted
touch the "Enter" button.
GO TO 1-UP DISPLAY
LANGUAGES
STORED CODES
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
G
98% 1000 RPM
LOAD RPM ENG RPM
14.2
57 PSI
BATT VOLT OIL PRES
G