MULTIQUIP Power DCA85USJ2 Operation And Parts Manual page 26

3. Once the "Adjust Backlight" menu item has been
highlighted touch the "Enter Button" to activate the
"Adjust Backlight" function
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
4. Use the "Arrow Buttons" to select the desired backlight
intensity..
ADJUST BACKLIGHT
5. Touch the "Menu Button" to return to the main menu.
ADJUST BACKLIGHT
6. Touch the "Menu Button" to exit the Main menu and
return to the engine parameter display
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONF G
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
PAGE 26 — DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11)
G
1000 RPM
98%
ENG RPM
LOAD RPM
14.2 57 PSI
BATT VOLT OIL PRES
DIAGNOSTIC DISPLAY
CONTRAST ADJUSTMENT
1. Starting at the single or four engine parameter display,
touch the "Menu Button".
0 1500 3000
1800 RPM
ENG RPM
COOL TEMP
2. The main menu will pop up on the display. Use the
"Arrow Buttons" to scroll through the menu until "Adjust
Contrast" is highlighted.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
3. Once the "Adjust Contrast" menu item has been
highlighted touch the "Enter Button" to activate the
"Adjust Contrast" function.
STORED CODES
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
ADJUST CONTRAST
4. Use the "Arrow Buttons" to select the desired contrast
intensity
ADJUST CONTRAST
5. Touching the "Menu Button" will take you back through
the menus.
1000 RPM
98%
ENG RPM
LOAD RPM
14.2 57 PSI
BATT VOLT OIL PRES
G
G