Removing A Slim Optical Drive - HP ProDesk 600 G1 Maintenance And Service Manual

6. If installing a USB 3.0 media card reader, you must use the USB 3.0 to USB 2.0 adapter and
connect the adapter cable from the media card reader to the USB 2.0 connector on the system
board labeled MEDIA.
NOTE:
drive connectors.

Removing a slim optical drive

CAUTION:
computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power cable and data cable from the back of the drive.
CAUTION:
avoid damaging the cable.
5. Push the green release lever on the right rear side of the drive toward the center of the drive (1),
then slide the drive forward and out of the bay (2).
Refer to System board connections on page 50
All removable media should be taken out of a drive before removing the drive from the
(Access panel on page
(Front bezel on page
When removing the cables, pull the tab or connector instead of the cable itself to
for an illustration of the system board
(Preparation for disassembly on page
38)
40)
37)
Drives
59