HP ProDesk 600 G1 Maintenance And Service Manual page 167

Disk transaction problem.
Cause
Either the directory structure is bad or there is a problem with
a file.
Drive not found (identified).
Cause
Cable could be loose.
The system may not have automatically recognized a newly
installed device.
The device is attached to a SATA port that has been hidden in
Computer Setup.
Drive responds slowly immediately after power-up.
Nonsystem disk/NTLDR missing message.
Cause
The system is trying to start from the hard drive but the hard
drive may have been damaged.
System files missing or not properly installed.
Hard drive boot has been disabled in Computer Setup.
Solution
In Windows 7, click Start, expand Computer, and right-
click on a drive. Select Properties, and then select the
Tools tab. Under Error-checking click Check Now.
In Windows 8, on the Start screen type e, and then click File
Explorer from the list of applications. In the left column,
expand Computer, right-click on a drive, select Properties,
and then select the Tools tab. Under Error checking click
Check.
Solution
Check cable connections.
See reconfiguration directions in the
Installation Problems on page 171
does not recognize the new device, check to see if the device
is listed within Computer Setup. If it is listed, the probable
cause is a driver problem. If it is not listed, the probable cause
is a hardware problem.
If this is a newly installed drive, run the Computer Setup utility
and try adding a POST delay under Advanced > Power-
On Options.
Run the Computer Setup utility and ensure Device Available
is selected for the device's SATA port in Security > Device
Security.
Run Computer Setup and increase the POST Delay in
Advanced > Power-On Options.
Solution
1. Perform Drive Protection System (DPS) testing in system
ROM.
1. Insert bootable media and restart the computer.
2. Boot to the windows installation media and select the
recovery option. If only a restore kit is available, then
select the File Backup Program option, and then
restore the system.
3. Install system files for the appropriate operating system.
Run the Computer Setup utility and enable the hard drive entry
in the Storage > Boot Order list.
Solving hard drive problems
Solving Hardware
section. If the system still
157