Installing A 3.5-Inch Or 2.5-Inch Hard Drive - HP ProDesk 600 G1 Maintenance And Service Manual

Installing a 3.5-inch or 2.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Install guide screws on the sides of the drive. 3.5-inch hard drives use standard 6-32 silver and
blue isolation mounting screws. 2.5-inch hard drives use metric M3 black and blue isolation
mounting screws.
NOTE:
the exterior of the hard drive bays. Extra guide screws for 2.5-inch hard drives are not provided
on the chassis but can be purchased from HP. Refer to
extra 6-32 isolation mounting guide screws location.
If you are replacing a drive, transfer the guides screws from the old drive to the new one.
If you are installing a 3.5-inch hard drive, install four silver and blue 6-32 isolation mounting
guide screws (two on each side of the drive).
If you are installing a 2.5-inch hard drive, install four black and blue M3 isolation mounting
guide screws (two on each side of the drive).
(Access panel on page
Four extra 6-32 isolation mounting guide screws for 3.5-inch hard drives are installed on
(Preparation for disassembly on page
38)
Drives on page 51
37)
for an illustration of the
Drives
63