Bypass; Identifying The Parts; Hcs80 Control Panel - Xerox DocuColor 7000AP User Manual

8. O pt io n al A c c es s o r i es

Bypass

The Bypass (only required when a second stacking
device is installed) transports collated sets through
the HCS80 to a connected finishing device or to
another HCS80.
If your system configuration has two stackers, the
bypass on the second stacker is not used.

Identifying the parts

HCS80 Control panel

1 Ready light
6 The Ready light blinks during initialization and is
8
7
2
constant when the HCS80 is in use or in standby
mode.
2 Sample set button
Press to have the HCS80 deliver the next collated
set to the top tray.
3 Unload button
Press once to lower the Stacker Tray and unlock
the front door.
4 Unload light
Illuminates when the Stacker Tray has reached the
down position and the front door can be opened.
5 Wait light
Blinks when the Stacker Tray is moving up or down.
10
9
3
5
6 Fault code display
1
Displays a code when a fault occurs in the
4
HCS80. Refer to the HCS80 fault code table
located in the Problem Solving section of this
chapter.
7 Top tray jam area
Blinks when there is a jam.
8 Bypass jam area
Blinks when there is a jam.
9 Stacker tray jam area
Blinks when there is a jam or the door is open.
10 HCS80 Keypad
8- 2 Do c u Co l or 7 00 0 AP / 80 0 0A P Us e r G ui d e