Xerox DocuColor 7000AP User Manual page 57

Problem
Multiple sheets feed from the
paper trays.
Paper jams when exiting the
Paper Trays
Output jams when exiting the
digital press to the Offset
Catch Tray
Excessive paper curl
It is difficult to perform
secondary operations on the
output prints, such as writing
on them or using adhesives.
Low gloss bands appearing
on printed output.
Do c u Co lo r 70 0 0A P /8 0 00 A P U s er G u i de
Suggested solutions
• Do not fill the paper trays above the MAX fill line indicator.
• Fan the paper, transparencies or drilled stock to separate the
joined sheets.
• Paper and transparencies may stick together if environmental
conditions are too dry and cause excessive static. Increase the
humidity level in the room to minimize static.
• Ensure that the edge guides of the paper tray fit snugly against
the paper stack.
• Do not fill the paper trays above the MAX fill line indicator.
• Close the tray slowly to avoid shifting the paper stack.
• When no other output device is present, the Offset Catch Tray
can hold up to 500 sheets of 24 pound (90 g/m
the catch tray when output approaches this limit to ensure
continuous production.
• Ensure the first sheet is not blocking the paper exit, particularly
for 11 x 17 inch (A3) output.
• Ensure that the correct paper weight and paper type are
selected.
• You can sometimes minimize curl problems by flipping the
paper over in the tray and making the copies again. If excessive
curl is still present, use a heavier paper.
• Empty the output device when output approaches this limit to
ensure continuous production.
This problem is caused by the oil used in the fusing process. The
problem can be reduced or eliminated by setting the prints aside for
one or two hours before performing a secondary operation on them.
Rubbing the print surface with a soft, clean cloth or eraser may also
help.
Running all weights at rated speed may result in a Cross Process
Low Gloss Band.
On the heavy-weight stocks, this low gloss band defect starts
approximately five inches (127 mm) from the lead edge and is
approximately three inches (76 mm) wide.
On light-weight stocks, the defect starts approximately six inches
(152 mm) from the lead edge and is approximately two inches (50
mm) wide.
NOTE: If this defect occurs, return the Productivity Setting to
the Single Paper Weight setting. If the defect still occurs after
running another print, call your Xerox service representative
for further assistance.
10 . B as i c Tr ou b le s h oo ti n g
2
) paper. Empty
10-3