Emerson 375 User Manual page 84

5-6
HART Error and Help Messages
"Poll Using Long Tag" allows the user to enter the long tag
of the device they want to connect to
"Poll Using Tag" allows you to enter the tag of the device
you want to connect to
Enter Device Long Tag
Enter the long tag that corresponds to the device you want
to connect to
Hart Application Error... "hc.ddl device revision x not
found."...Refresh System Card...See User's Manual and
Programming Interface for details
Hart Application Error... "registry failure"...Reinstall System
Files...See User's Manual for details
Voltage is currently detected at the Fieldbus Terminals.
Reconfigure unit and try again.
CDC Error..."failure while switching to HART"...Reinstall
System Files...See Users's Manual for details
DD Error..."tokenizer mismatch"...DD version
<manufacture name, device name, dev. rev. #, and
DD rev. #>; HART application <version x.y>; HART app
version x.y...Reinstall DD...See Programming Interface for
details
DD Error..."linker mismatch"...DD version x.y; HART app
version x.y...Reinstall DD...See Programming Interface for
details
DD Error..."developed-to mismatch"...DD version
<manufacture name, device name, dev. rev. #, and
DD rev. #>; HART application <version x.y> ...See
Programming Interface for solution.
Warning: this DD is untested with the current Hart App ver
<manufacture name, device name, dev. rev. #, and
DD rev. #>...you may experience unexpected or
inappropriate results...See Programming Interface for
details on DD updates...Do you want to accept these risks
and proceed?
DD Error..."tested-to sequence mismatch"...DD version
<manufacture name, device name, dev. rev. #, and
DD rev. #>; HART application <version x.y>; HART app
version x.y...See Programming Interface for solution
Troubleshooting
Description
This is a help message.
This is a help message.
This is a help message.
This is a help message.
This error message appears when an
expected version of hc.ddl is not
found.
This error message appears when
the information describing the
location of the DD's is not found in
the registry.
This error message appears when
the HART app found voltage on the
FF connector during initialization and
during reconnection to a device.
This error message appears when
the HART app fails to put the CDC in
HART mode for talking to a HART
device.
This error message appears when
the version of the tokenizer used to
tokenize the DD is not what the
HART app expects.
This error message appears when
the version of the linker used to link
the DD is not what the HART app
expects.
This error message appears when
the DD was developed and tested
using a later HART app revision.
This error message appears when
the DD was not tested and verified
with the HART app.
This error message appears when
the DD was tested with a previous
version but not with this version of the
HART app