Gobo Replacement - Chauvet Q-Spot 360-LED User Manual

Gobo Replacement

Q-Spot™ 360-LED User Manual Rev. 4
1. Turn the product off and disconnect from power.
2. Unlock the gobo cover and slide it away.
3. Separate the gobo plate away from the gobo wheel by pushing it toward the front of
the moving head (direction 1 in the diagram). Be careful not to push the gobo out of
the gobo plate.
4. Extract the gobo plate by pulling it outward (direction 2 in the diagram).
5. On a flat surface, remove the expansion ring that holds the gobo in place and
remove the gobo from the gobo plate.
6. Insert a new gobo and hold it in place with the expansion ring.
7. Slide the tip of the gobo plate under the pressure plate near the center of the gobo
wheel.
8. Push the gobo plate inwards. DO NOT force the gobo plate into the gobo wheel slot.
If correctly installed, the gobo plate should easily snap itself into the gobo wheel slot.
Gobo Plate #1 contains a magnet used by the product for positioning purposes.
When replacing gobos, be sure to return gobo plate #1 to position #1 on the
wheel.
Setup
9