Left-Hand Stalk Switch - Volvo XC90 Owner's Manual

Stalk switch positions
Short flash sequence, direction indicators
Continuous flash sequence, direction
indicators
Main beam flash
Home safe lighting and switching of
dipped and main beam
Factory settings.
1
Direction indicators
Continuous flash sequence
– Move the stalk switch up or down to end
position (B).
The stalk switch remains in its end position
and is moved back manually, or automatically
by steering wheel movement.
Short flash sequence
– Move the stalk switch up or down to
position (A) and release, the stalk switch
then returns to its home position, or move
the stalk switch to position (B) and move
it directly back to the home position.
The direction indicators flash three times.
Short flash sequence interrupted immediately
if indicating is started in the opposite direc-
tion.
Switching, main and dipped beam
The remote control key must be in position II
for main beam to be switched on.
1. Turn the headlamp control clockwise to
the end position, see page 64.
2. Move the stalk switch towards the steer-
ing wheel to the end position (D) and
release.
02 Instruments and controls

Left-hand stalk switch

Main beam flash
– Move the stalk switch gently towards the
steering wheel to position (C).
Main beam comes on until the stalk switch is
released.
Home safe lighting
Some of the exterior lighting can be kept
switched on to work as home safe lighting
after the car has been locked. The standard
1
delay is 30 seconds , but can be changed to
60 or 90 seconds.
1. Remove the remote control key from the
ignition switch.
2. Move the stalk switch towards the steer-
ing wheel to the end position (D) and
release.
3. Get out of the car and lock the door.
02
67