Volvo XC90 Owner's Manual page 194

07 Wheels and tyres
Changing wheels
5. Use the wheel brace to loosen the wheel
bolts ½-1 turn. Turn anticlockwise.
07
192
WARNING
Never position anything between the
ground and the jack, nor between the jack-
ing point and the jack.
WARNING
If the jack is positioned incorrectly, the car
could fall. Risk of injury.
6. Place the jack under the jacking point and
crank it up towards the car floor. There is
an recess in the plastic cover at each
anchorage point. Check that the jack sits
securely in the anchorage. Then adjust
the jack so that its foot is positioned verti
cally under the anchorage. See illustra-
tion.
IMPORTANT
The ground must be firm, smooth and
level.
7. Lift the car until the wheel is free.
8. Remove the wheel bolts and lift off the
wheel.
Fitting the wheel
1. Clean the contract surfaces on the wheel
and hub.
2. Put on the wheel. Screw in the wheel
bolts.
3. Lower the car so that the wheel cannot
rotate.
4. Tighten the wheel bolts alternately and in
torque steps. Tightening torque: 140 Nm
(14.0 kpm). It is important that they are
tightened to the correct torque. Check
with a torque wrench.
5. Screw the jack all the way down before
returning it to the cargo area. Then secure
it in place.