Volvo XC90 Owner's Manual page 192

07 Wheels and tyres
Warning triangle* and spare wheel*
NOTE
The spot under the car is only intended for
the car's original spare wheel. Do not
place any other wheels there.
Spare wheel – refitting
It is best to have two people put the spare
wheel back in place. One person to crank and
the other to guide the wheel.
1. Crank out the cable and place its anchor
in the centre hole of the wheel.
2. Slowly crank (clockwise) the cable in a
bit.
3. Angle the wheel so that it comes in over
the exhaust system.
4. Hold down the rear edge of the wheel
while cranking it in.
5. Place the wheel above the rear axle,
against the floor.
6. Crank to the stop point.
07
7. Check that the wheel is properly secured.
*
190
Option/accessory, for more information, see Introduction.
WARNING
Check that the right mounting points are
being used. A production anchorage with
pin is located between the jacking points.
This is not strong enough to use to lift the
car. If you are unsure about the location of
the jacking points, Volvo recommends that
you contact an authorised Volvo work-
shop. An incorrectly fitted jack could dam-
age the door and body.
Tools - returning into place
The tools and jack* must be returned to their
correct places after use. The jack must be
cranked to the correct position, see the pre-
ceding illustration, in order to have space.
IMPORTANT
The tools and jack* must be stored in the
intended location in the car's cargo area
when not in use.
First aid*
A case with first aid equipment is located in
the cargo area.