Volvo XC90 Owner's Manual page 199

Inflating the tyres
The car's original tyres can be inflated by the
compressor.
1. The compressor must be switched off.
Make sure that the switch is in position 0
and locate the cable and air hose.
2. Unscrew the wheel's dust cap and screw
in the air hose valve connection to the
bottom of the thread on the tyre's air
valve.
WARNING
Do not leave children in the car without
supervision when the engine is running.
WARNING
Inhaling car exhaust fumes can result in
danger to life. Never leave the engine run-
ning in sealed areas or areas that lack suf-
ficient ventilation.
3. Connect the cable to one of the car's
12 V sockets and start the car.
4. Start the compressor by flicking the
switch to position I.
IMPORTANT
Risk of overheating. The compressor must
not run for more than 10 minutes.
5. Inflate the tyre to the pressure specified
on the tyre pressure decal. (Release air
using the pressure reducing valve if the
tyre pressure is too high.)
6. Switch off the compressor. Detach the air
hose and cable.
7. Refit the dust cap.
Changing the sealing fluid canister
Replace the bottle when the expiration date
has passed. Treat the old bottle as environ-
mentally hazardous waste.
WARNING
The bottle contains 1.2-Ethanol and natu-
ral rubber-latex.
Harmful if ingested. Could result in allergic
reaction in the event of skin contact.
Avoid contact with the skin and eyes.
Store out of the reach of children.
07 Wheels and tyres
Emergency puncture repair*
NOTE
Leave the container at a collection point
for storing dangerous waste.
*
Option/accessory, for more information, see Introduction.
07
197