Volvo XC90 Owner's Manual page 191

Spare wheel – removing
The spare wheel is located under the car. The
jack*, tool kit* and crank are located under
the floor hatch. The crank is in two parts. One
part is in the tool kit, and the other is under
the tool kit.
NOTE
There is a puller spanner in the tool kit to
remove the hub cap (certain wheel
options).
The location of the jack varies:
Cars seating seven
Cars seating five
Proceed as follows to release the spare
wheel:
1. Lower the bottom of the tailgate and lift
up the floor hatch in the cargo area.
2. Take the two parts of the crank and
assemble.
3. Fit the crank in the winch.
07 Wheels and tyres
Warning triangle* and spare wheel*
4. Loosen the tyre by cranking anticlockwise
until you reach the stop.
NOTE
The cable could damage the car if it hangs
free while driving.
5. Release the wheel from the cable and
wind up the cable clockwise.
6. Place the punctured tyre in the cargo
area. The tool kit contains a plastic bag
for the tyre.
*
Option/accessory, for more information, see Introduction.
07
189