Table of Contents
Advertisement
Chapter 8 VLAN Profile
Table 23 EPON VLAN Profile Setup (continued)
LABEL
VLAN Type
VLAN ID
Priority Src
Downstream
Default VLAN
Rule
Action
VLAN ID
Priority Src
Index
Active
Direction
Classifier
Value
88
DESCRIPTION
This field is applicable when you select Add or Exchange in the Action field.
Select a standard Ethernet type code identifying the frame and indicates whether
the frame carries IEEE 802.1Q or IEEE802.1ad tag information.
For untagged frames, the system sets the VLAN type to 8100 regardless of your
setting here.
For tagged frames, the system sets the VLAN type (8100, 88A8 or 9100) that you
specify.
Enter a VLAN ID (from 1 to 4094) of the packet.
If you select Exchange in the Action field, this replaces the packet's VLAN ID.
Select Original if you don't want to change the priority of the packets.
Select Priority Profile to change the packet priority based on the settings in the
priority profile configured for the ONU in the ONU Setup screen. If no priority
settings are configured for the matched packets, the TOS-COS settings in the
Priority Profile screen apply.
Configure the default settings for the incoming traffic (from the OLT to the ONU) that
does not match any VLAN rule.
Specify the action to perform on the packets.
Select Delete to delete a VLAN tag from the incoming packets.
Select Exchange to replace the VID with the one specified in the VLAN ID field.
Select None to send the packets without any changes.
Enter the VLAN ID (from 1 to 4094).
If you select Delete, the ONU deletes the outer VLAN tag (that matches this VLAN
ID) from incoming packets.
If you select Exchange in the Action field, this replaces the packet's VLAN ID.
Select Original if you don't want to change the priority of the packets.
Select Priority Profile to change the packet priority based on the settings in the
priority profile configured for the ONU in the ONU Setup screen. If no priority
settings are configured for the matched packets, the TOS-COS settings in the
Priority Profile screen apply.
This field displays the index number for the VLAN rule.
Select this option to enable the VLAN rule.
This field displays the direction of the traffic to which the rule applies.
Upstream means traffic from the ONU to the OLT while downstream traffic goes
from the OLT to the ONU.
Specify the packet type to check. Choices are Ethertype, IPv4 Protocol and
VLAN.
Select Ethertype to check the Ethernet type of the packet.
Select IPv4 Protocol to check the IPv4 protocol number of the packet.
Select VLAN to check the VLAN ID of the packet.
Enter the packet type value to check.
If you select Ethertype in the Classifier field, enter the Ethernet type number in
hexadecimal value (0x0000 - 0xff0f). The 0x prefix is already entered for you. Refer
to
Table 25 on page 95
for common Ethernet type numbers.
If you select IPv4 Protocol in the Classifier field, enter an IPv4 protocol number (1-
255). Refer to
Table 26 on page 96
If you select VLAN in the Classifier field, enter a VID (1-4094).
for common protocol numbers.
OMC-2301 User's Guide
Advertisement
Table of Contents
Troubleshooting
