ZyXEL Communications OMC-2301 User Manual page 72

Chapter 6 Basic Setting
Table 17 EPON Profile (continued)
LABEL
Maximum
Downstream
Bandwidth
Maximum
Downstream Burst
Size
Downstream Policing per Queue
Active
Maximum Queue 0
Bandwidth
Maximum Queue 1
Bandwidth
Maximum Queue 2
Bandwidth
Maximum Queue 3
Bandwidth
Downstream Priority Queue Size (1-Port ONU only)
Active
Queue 0 Size
Queue 1 Size
Queue 2 Size
Queue 3 Size
1-Port ONU PHY Configuration
Power Down
Speed/Duplex
Auto-negotiation
Flow Control
Address Learning
72
DESCRIPTION
This field is applicable when you select Downstream Policing. Downstream
traffic refers to traffic from the OLT to the ONU.
Specify the maximum downstream bandwidth allowed for the ONU.
The number you entered is multiplied by 64.
This field is applicable when you select Downstream Policing. Downstream
traffic refers to traffic from the OLT to the ONU.
Specify the maximum downstream burst size that an ONU is allowed to send
for a single traffic burst. This assigns more bandwidth to the ONU for a short
burst period without changing the profile settings.
Select Active to apply the bandwidth limit to the upstream traffic on the queues
then configure the settings in the field below. Downstream traffic refers to traffic
from the OLT to the ONU.
Specify the maximum downstream bandwidth for packets in queue 0.
The number you entered is multiplied by 100.
Specify the maximum downstream bandwidth for packets in queue 1.
The number you entered is multiplied by 100.
Specify the maximum downstream bandwidth for packets in queue 2.
The number you entered is multiplied by 100.
Specify the maximum downstream bandwidth for packets in queue 3.
The number you entered is multiplied by 100.
Select Active to set the queue size for the downstream traffic.
Specify the size (in byte) for queue 0.
The number you entered is multiplied by 128.
Specify the size (in byte) for queue 1.
The number you entered is multiplied by 128.
Specify the size (in byte) for queue 2.
The number you entered is multiplied by 128.
Specify the size (in byte) for queue 3.
The number you entered is multiplied by 128.
Select this option to disable the connection to the ONU.
Select the link speed and duplex mode (10M/Half, 10M/Full, 100M/Half, 100M/
Full or 1000M/Full) for the connection to the ONU.
Select this option to establish the connection to the ONU using auto-negotiation
for the link speed and duplex mode.
IEEE802.3x flow control is used in full duplex mode to send a pause signal to
the sending port, causing it to temporarily stop sending signals when the
receiving port memory buffers fill.
Select this option to enable flow control for the connection to the ONU.
MAC address learning reduces outgoing broadcast traffic. For MAC address
learning to occur on a port, the port itself must be active with address learning
enabled.
OMC-2301 User's Guide