ZyXEL Communications OMC-2301 User Manual page 156

Chapter 19 Introducing the Commands
Table 49 Command Summary: Enable Mode (continued)
COMMAND
disable
enable
erase running-config
user-config
exit
help
history
line-card- <line-card-list>
reset
logout
mac-flush
<port-number>
onu <port-number> <llid-
firmware- list>
upgrade
onu reset <port-number> <llid-
list>
ping <ip|host-name>
help
port-test <port> <llid-list>
reload config <index>
session- <1-1440>
timeout
show classifier-filter-
profile
dba-mode
epon
156
DESCRIPTION
Exits Enable (or privileged) mode.
Accesses Enable (or privileged) mode.
Resets the current configuration to the
factory default settings.
Resets all settings to the factory defaults
except the following settings:
•
•
•
Exits Enable (or privileged) mode.
Displays help information.
Displays a list of command(s) that you
have previously executed.
Rests the specified line card(s).
Exits Enable (or privileged) mode.
Clears the MAC address table.
Removes all learned MAC address on
the specified port(s).
Upgrades the firmware to the specified
ONU(s) on the specified port.
A port number contains three or four
digits, such as 101 or 1402. The digit(s)
before 0 in a port number corresponds to
the card slot on the OLT, and the last digit
denotes the port type (1 for PON port
and 2 for uplink port).
Resets the connection the ONU. This is
for troubleshooting purposes.
Sends Ping request to an Ethernet
device.
Sends Ping request to an Ethernet
[ size <0-1472>
device with the specified parameters.
][ -t ]
Displays command help information.
Starts the loopback test to the specified
ONU.
Reboots the system.
Sets the management session timeout
(in minutes).
Displays classifier filter profile summary
table.
Displays detailed settings of the specified
<profile-name>
classifier filter profile.
Displays current DBA (Dynamic
Bandwidth Allocation) method the device
uses.
Displays the status of all PON ports.
SNMP
syslog
NTP time server
OMC-2301 User's Guide