ZyXEL Communications OMC-2301 User Manual page 189

Gepon olt management card
Table of Contents

Advertisement

where
<name>
rule <1-7>
action <delete|
exchange| none>
new-vid <1-4094>
priority-src
<original| priority-
profile>
type <ethertype| ipv4|
vlan>
value
ethertype:<0x0000-
0xFF0F>|ipv4<1-
255>|vid <1-4094>>
Use these commands to create a VLAN profile for the downstream traffic. You can also create
VLAN profile for the upstream traffic, replace
The following shows an example rule on the incoming packets from the OMC to the ONU.
• Create a VLAN profile called
• Enable the service profile.
• Enable a rule for downstream traffic.
• Set the rule to check packets with a VLAN ID of 14.
• Set the rule action on the matched packets. This rule removes the VLAN tag from the
incoming packets.
sysname(config)# vlan-profile VProfile
sysname(config-vlan-profile)# active
sysname(config-vlan-profile)# downstream rule 1 active
sysname(config-vlan-profile)# downstream rule 1 type vlan
sysname(config-vlan-profile)# downstream rule 1 value 14
sysname(config-vlan-profile)# downstream rule 1 new-vid 14
sysname(config-vlan-profile)# downstream rule 1 action delete
sysname(config-vlan-profile)#
OMC-2301 User's Guide
= Specifies a VLAN profile.
= Specifies a rule to configure.
= Specify the action to perform on matched packets.
Enter
to insert a VLAN tag to outgoing packets
delete
or delete the VLAN tag from incoming packets.
Enter
to replace the VID with the one
exchange
specified in the VLAN ID field.
Select
to forward packets without any changes.
none
= Enter a VLAN ID (from 1 to 4094) of the packet.
For the
action, this replaces the packet's
exchange
VLAN ID.
= Enter
if you don't want to change the priority
original
of the packets.
Enter
priority-profile
based on the settings in the priority profile configured for
the ONU. If no priority settings are configured for the
matched packets, the TOS-COS settings in the priority
profile apply.
= Sets the rule type.
= Specify the Ethernet type, protocol type or VLAN ID.
downstream
.
VProfile
Chapter 20 Command Examples
to change the packet priority
with
.
upstream
189

Advertisement

Table of Contents
loading

Table of Contents