Installing And Removing The Memory Modules; Installing & Removing Dimms; Removing Memory Modules - Supermicro X9DRD-iF User Manual

2-4

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with P1-
DIMMA1.
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
COM2
JUIDB
BMC CTRL
BMC
LAN CTRL FAN8
JPG1
JPB1
JI2C1
JI2C2
PCH
JBT1
BIOS
C1 D1
CPU1
JPW5
FAN4
JVR1
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.

Removing Memory Modules

Press both notches on the ends of the DIMM module to unlock it. Once it is loos-
ened, once it is loosened, remove it from the memory slot.
modules to prevent any possible damage.
USB2/3 USB0/1
COM1
VGA
USB6
FAN7 LAN2 LAN1
IPMI_LAN
LAN
SP1
CTRL
CLK CTRL
JPW4
X9DRD-iF
Rev. 1.10
G1 F1 E1
H1
CPU2
B1 A1
JBAT1
JOH1
:OH LED
LED2
CAUTION
2-11
Chapter 2: Installation
Notches
Release Tabs