Supermicro X9DRD-iF User Manual page 13

Jumper
JBT1
JI C1/JI C2
2 2
JPB1
JPG1
JPL1
JPME1
JPME2 (X9DRD-iF)
JWD1
Connectors
COM1/COM2
(COM1 only: X9DRD-LF)
(COM1/COM2: X9DRD-iF)
FAN1~8
(FAN1~6: X9DRD-LF)
(FAN1~8: X9DRD-iF)
I-SATA 0~5 (X9DRD-iF)
I-SATA 0~1 (X9DRD-LF)
JBAT1
JD1
JF1
JIPMB1 (X9DRD-iF)
JL1 (X9DRD-iF)
JOH1 (X9DRD-iF)
JPI C1
2
JPW1
JPW2/3
JPW4/5
JSD1 (X9DRD-iF)
JSTBY1 (X9DRD-iF)
JTPM1
Note: PCI-E slots support Low-Profile MD2 form factor for devices/add-on
cards that are shorter than 167.64mm or 6.59" (in) in length only.
X9DRD-iF/LF Jumpers
Description
Clear CMOS
SMB to PCI-E Slots
BMC Enabled
VGA Enabled
GLAN1/GLAN2 Enable
Management Engine (ME)
Recovery Mode Enable
Management Engine (ME)
Manufacture Mode Select
Watch Dog Timer Enable
Connectors
Description
Backplane COM Port1/Front Accessible COM2 Header
CPU/System Fan Headers
Four SATA 2.0 and Two SATA 3.0 Connectors from AHCI
Two SATA 3.0 Connectors from AHCI
Onboard Battery (See Chpt. 3 for Used Battery Disposal)
Speaker/Power LED Indicator
Front Panel Control Header
4-pin External BMC I
Chassis Intrusion
Overheat LED Indicator
Power Supply SMBbus I
24-Pin ATX Main Power Connector (Warning on Pg. 1-6.)
12V 8-Pin Power Connectors (See Warning on Pg. 1-6.)
12V 4-Pin Power Connectors (See Warning on Pg. 1-6.)
SATA DOM (Device on Module) Power Connector
+5V Standby Power Header
TPM (Trusted Platform Module)/Port 80
1-5
Chapter 1: Overview
Default Setting
See Chapter 2
Off (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Normal)
Pins 1-2 (Reset)
C Header (for an IPMI Card)
2
C Header
2