Operation Panel - Star Micronics NP-266S Product Specifications

4.6 Operation panel

The following operation part is at the side of the printer unit.
1) ALM (red) ［alarm lamp］
※The pattern of the indication is in the following chart.
2) ENTRY［Setting switch］
3) FEED SW
Display pattern
1
0
1
0
0.1sec
1
0
0.1sec
0.05sec
1
0
0.05sec
2.2sec
1
0
2.2sec
0.2sec
1
0
0.2sec 1.0sec
0.5sec
1
0
0.5sec
D-F0399 NP-266S/366S Specifications Ver.0.01 Provisional
Will turn on (or blink) when printer is on error status.
Will turn on/ blink/ turn off when rewriting Flash Rom
Switch to set the setting of the memory switch and setting mode.
Also, used in rewriting the Flash ROM.
［Paper feed switch］
Switch to feed paper in the normal direction
Switch to set the setting of the memory switch, and setting mode
Also, used in rewriting Flash Rom, and self-printing.
Printer status
Normal status
Print (receive) ready
No paper
Head up status
F/W write mode
BOOT rewriting mode
Head temp high (80˚c)
Wrong head connection
Auto-cutter error
Near empty
Load the paper
Set head down
Set the power on again after comletion
Set the power on again after comletion
Printer returns normal at head temp of 60˚c
Connect head cable properly
Remove jammed paper and turn
or input /RESET signal
Load the paper
17
How to solve the problem