Table of Contents
Advertisement
35) Data input control
Code
Description:Selects valid device where data input is possible through host computer.
* Each bit of "n" has the following meaning.
Bit
0
Printer
1
Not defined
2
Not defined
3
Not defined
4
Not defined
5
Not defined
6
Not defined
7
Not defined
* If printer is not in "no selection" status, printer will discard all received data until it is in
the selection status by this command.
* Even if printer is in no selection status, the status may become BUSY by printer
operation.
* The default value of "n" is [01] h.
36) Print position alignment
Code
Description : Aligns all data to be printed on the assigned position in a line.
* "n" values are assigned to:
n (Hex)
00
01
02
* This command is valid only when it is input at the head of a line.
* The default value of "n" is [00] h.
37) Cut
Code
* Cut the paper.
* Effective at the head of a line
* Feeds paper by 3mm after paper cut to prevent from paper jam.
38) Select character code table
Code: [1B] h + [54] h + n
* Select the character code table.
* n means as follows.
n(Hex)
00
01
02
03
Default of n value is as per memory switch setting (MS2-2, MS2-3).
By executing printer initialization, this setting will be returned to value set by memory switch
(MS2-2, MS2-3).
D-F0399 NP-266S/366S Specifications Ver.0.01 Provisional
:<< ESC = n >>
: [1B] h + [3D] h + n
Function
0
Invalid
:<< ESC a n >>
: [1B] h + [61] h + n
Position
Left
Center
Right
:<< ESC i >>
: [1B] h + [69] h
:<< ESC T n>>
Font table
Japanese
Chinese
Korean
Greek
* [00≤n≤FF] h
Values
1
Valid
* [00≤n≤03] h
33
* [00≤n≤02] h
Advertisement
Table of Contents
