Star Micronics NP-266S Product Specifications page 33

23) Printer status transmission
Code
Sends current printer status
* Status to be transmitted consist of 1 byte and the content is explained in the chart below.
* Only 1 byte will be sent after confirming the receivable status (SPACE status of CTS
signal) from host.
* It will wait till receivable status when the host can not receive the staus (MARK status of CTS signal).
bit
0
1
2
3
4
5
6
7
* Make sure that command is issued before transmission of print data.
(commands are stored in the input buffer and executed sequentially)
* Reception is available except in the buffer full status.
* The commands above are valid only for serial interface.
24) Inverted character set and reset
Code
Sets or resets the inverted character function
* "n is only valid for the LSB (b0)
* LSB (b0) has the following meaning
b0
0 resets inverted character
1 sets inverted character
* The command is only valid when it is assigned at the beginning of a line.
* The default value of n is [00] h.
25) 90° clockwise rotated character set and reset
Code
Sets and resets 90° clockwise rotated character.
* Underline cannot be assigned to the 90° clockwise rotated character.
* "n" has the following meaning.
n(hex)
00
01
* Default value for "n" is [00] h.
26) Absolute position set
Code
Print start position is assigned by dots in 1/203rd of inch from the beginning of line.
* Divide the value of dot by 256, place quotient to n2, and remainder to n1.
* The print start position is n1 + n2 x 256 from top of the line.
* Setting which exceeds end of line is ignored.
* If the command is received in the middle of line, the current position is also valid.
D-F0399 NP-266S/366S Specifications Ver.0.01 Provisional
:<< ESC v >>
: [1B] h + [76] h
Functions
paper near empty
platen open
paper end
head temp. abnormal
cutter problem
Undefined
paper remove sensor
information
not defined
: [1B] h + [7B] h + n
Description
: [1B] h + [56] h + n
description
reset 90° rotated character
set 90° rotated character
:<< ESC $ n1 n2>>
: [1B] h + [24] h +n1 +n2
Value
0
paper present
normal
paper present
normal
normal cutter problem
no paper
:<< ESC { n >>
* [00≤n≤FF] h
:<< ESC V n >>
* [00≤n≤01] h
* [00≤n1≤FF] h
* [00≤n2≤03] h
29
1
near empty
head open
no paper
Temp. high
paper present