Install Switch Housing; Connect Wires; Install Switch Housing Cap Screws - Casablanca ESTRADA Owner's Manual

™
E
STRADA

INSTALL SWITCH HOUSING

Step 13. Install 2 of the 3 switch housing screws onto
the fan adapter plate, leaving 1/8" threads visible. Feed
the wire connector from the fan through the center of the
2 Switch
switch housing.
Housing
Align the 2 screws on the adapter plate with the keyhole
Screws
slots of the switch housing. Raise the switch housing,
pulling on the fan wire connector to assure no wires get
pinched.
Turn the switch housing counter clockwise, engaging the 2
Switch
screws. Install the third screw and tighten all 3 screws.
Housing
Switch
Housing
Screw

CONNECT WIRES

Step 14. Plug the wire connector for the fan into the wire
connector for the switch housing. Assure that the clip
from the fan connector engages the notch on the switch
housing connector.
Clip Notch

INSTALL SWITCH HOUSING CAP SCREWS

Step 15. If you are installing a light fi xture, please refer
to the "3-Speed Optional Light Fixture Installation" on
the next page.
If no light fi xture is being installed, carefully push the
wires and components back into the switch housing. Align
the guiding pegs of the cap to the non-threaded holes of the
switch housing. Reinstall the switch housing cap screws
removed in Step 12.
9
4743040 AT0907