Toshiba ESTUDIO170F Operation Manual page 215

Clearing a Recording Paper Jam - continued
10
Remove the Process
Unit
Lift up and holding the green
handle, gently pull out the Pro-
cess Unit.
CAUTION:
Always hold the Process
Unit by the green handle.
Remove the Jammed
11
Paper
(Paper Feed Area)
Remove the jammed paper in
the direction of the arrow.
Avoid tearing the paper.
CAUTIONS
• Do no touch the image
Transfer Roller.
• The black colored fuser
housing may be hot if
the machine was in use
prior to this paper jam.
NOTE:
It is recommended to fold
the edge of jammed paper
as shown in the figure when
you remove the jammed pa-
per.
12
Remove the Jammed
Paper (Fuser Area)
If the paper is jammed partway
through the Fuser Unit (black
colored housing), remove the
jammed paper in the direction
of the arrow. Avoid tearing the
paper.
NOTE:
If a paper is jammed before
toner on the paper is fused,
be careful not to stain your
hand or fingers with toner
when removing the jammed
paper.
13
OPEN THE RX
Cover
Open the RX Cover as shown
above.
Remove the Jammed
14
Paper
(Paper Exit Area)
Pull the leading edge of the re-
cording paper which has been
output in the exit.
Remove the jammed paper in
the direction of the arrow.
Avoid tearing the paper.
213