Document Loading - Toshiba ESTUDIO170F Operation Manual

Document Loading

1
Remove Attached
Items
Remove any staples, paper
clips, or other items from your
document before feeding it into
the facsimile.
When scanning Legal-size doc-
uments, extend the Document
Support Extension and Docu-
ment Exit Tray Extension.
82
2
Place Document Pages on the Document
Support
Up to 30 sheets (Letter-size)
can be loaded and sent at a
time.
Stagger the leading edges of
the sheets slightly and insert
them into the document feeder.
Adjust the Document Guides to
fit the width of the document.
Load the document face down
on the Document Support. The
first page of your document
should be at the bottom of the
Document Support.
Gently insert the leading edge
of the paper into the facsimile
as shown. The facsimile waits
2 seconds, then pulls the docu-
ment into the scanning area
and stops.
When a Carrier Sheet is used,
documents must be sent one
page at a time (manually fed).
When the document sheet is
longer the Document Support,
assist it with your hand to in-
sure proper feeding.
3
Adjust the Settings
After the facsimile pulls the
document into the scan posi-
tion slightly and stops, you
may change the resolution and
contrast settings. (It may also
be changed before or during
the document loading.)
To cancel a document already
set and pulled in, press:
STOP
If your document is extremely
dark or light, or if it contains
photographs, you may wish to
adjust the contrast and resolu-
tion settings. See the following
pages.