Communication Report Print
You can request a communica-
tion report every time a docu-
ment is sent. If you desire a
communication report every
time you send a document, set
this function to ON as a default
(see page 178).
If you plan to use communica-
tion reports only occasionally,
use this procedure. The TX Re-
port key allows you to obtain a
report for one communication
only.
You can activate this option
while programming an Abbrevi-
ated Dial Number (see page
65) or One Touch Dial Key set-
ting (see page 71) if communi-
cation with a specific remote
party always requires this op-
tion.
1
Load the Document
Load the document face down
in the Document Support (see
page 82).
Adjust the resolution and con-
trast if desired (see pages 83
and 84).
JAN-31 09:43 AM 100%
AUTO RECEIVE
2
Display the TX
REPORT Menu
Select the function key on the
Operation Panel.
Press:
TX REPORT
TX REPORT
1.ALWAYS
2.ON ERROR
3.OFF
3
Select the Option
To set the e-STUDIO170F to
always print a communication
report, press:
To set the e-STUDIO170F to
only print a communication re-
port when an error condition is
encountered, press:
To set the e-STUDIO170F to
never print a communication
report, press:
JAN-31 09:43 AM 80%
ENTER TEL NUMBER
4
Enter the Facsimile
Number
Enter the number of the remote
facsimile using any of the fol-
lowing dialing methods.
•
One Touch Key Dialing
... See page 89
•
Abbreviated Dialing
... See page 90
•
Alphabet Dialing
... See page 91
•
Keypad Dialing
... See page 92
177