Compuprint 10200 User Manual page 138

Messages
BUFFER OVERFLOW
CHARACTER LOST
DATA SET OFF
JAM FRONT1 PATH
CHECK PAPER
JAM FRONT2 PATH
CHECK PAPER
NO PATH AVAILABLE
NVM CHANGE
REMOVE PAPER
Indication
A buffer overflow condition
occurred (for the serial
interface).
The DSR Signal is not
connected to the printer and
is not ready for data transfer
(if the serial interface is
selected). This condition may
happen in a remote
connection (via modem) and
the DSR (DATA SET
READY) signal is missing.
A paper jam error condition
occurred in the Front1 paper
path
A paper jam error condition
occurred in the Front2 paper
path
An electromechanical failure
occurs in the lower or upper
tractor paper paths.
If this error is displayed
during the printer power on,
an NVM error condition
occurs
Solution
Turn the printer off and on again, or press
the
PROGRAM
successively to clear the buffer.
Press the
ON LINE
condition.
Check the paper path and remove the
jammed paper. Press the
reset the error condition.
Check the paper path and remove the
jammed paper. Press the
reset the error condition.
Call Service.
Turn the printer off and then on again. If
the problem is not solved call Service.
134
and key
ON LINE
key to reset the error
key to
ON LINE
key to
ON LINE