Compuprint 10200 User Manual page 106

Storing the values
HEX DUMP NO
↑
→ or ←
STORE? QUIT
→ or ←
STORE? SAVE
→ or ←
STORE? CURRENT
PROG
EXIT
This setting does not save any of the new values set. The values set previously
STORE? QUIT
will be used.
The values set are stored permanently (in the NVM) and will be used until they
STORE? SAVE
are changed by the operator.
The values set are valid until the printer is turned off. When you turn the printer
STORE? CURRENT
on again, the values set in the preceding setup setup will be used.
At this point the Program Configuration Setup is finished. You exit pressing the PROGRAM key.
102