Intel ® Local Control Panel Interconnects; Table 52. 50-Pin Control Panel Connector - Intel SR1500 - AXXMINIDIMM DDR-2 RAID Controller Cache Memory Manual

Server chassis/server system
Hide thumbs Also See for SR1500 - AXXMINIDIMM DDR-2 RAID Controller Cache Memory:
Table of Contents

Advertisement

Intel® Server System SR2500AL
®
8.2
Intel
Local Control Panel Interconnects
®
The Intel
Local Control Panel module includes the control panel interface board and an
interposer board. Connectors on the control panel interface board are cabled to matching
connectors on the interposer board. When the pre-assembled control panel module is installed
into the chassis, a card edge connector on the interposer card is blind mated with a slot edge
connector on the backplane. This section will define the pin-out for each connector and header
found on both the control panel interface board and interposer board.
A 64-pin card edge connector on the interposer board is used to route signals to/from
the backplane to the control panel interface board. The backplane is used as a conduit
for communication to the server board.
Signals from the card edge connector are routed to control panel interface board through
matching 50-pin connectors on the interposer board and control panel interface board.
The 50-pin connectors are attached using a small 50-pin flat cable.
USB signals from the card edge connector are routed to the control panel interface
board through matching 10-pin connectors on the interposer board and control panel
interface board. The 10-pin connectors are attached using a small 10-pin round cable.
A 4-pin IPMI header (not used).
A 4-pin NMI/Temp Sensor header.
The following tables provide the pin-outs for each connector.
PIN
SIGNAL NAME
A1
GND
A2
VGA_VSYNC_FP_L
A3
GND
A4
VGA_HSYNC_FP_L
A5
GND
A6
VGA_BLUE_FP
A7
GND
A8
VGA_GREEN_FP
A9
GND
A10
VGA_RED_FP
A11
GND
A12
GND
A13
FP_RST_BTN_L
A14
GND
A15
NC_FP_CHASSIS_L
A16
GND
A17
BP_I2C_5V_SDA
A18
BP_I2C_5V_SCL
A19
GND
A20
FP_NMI_BTN_L
A21
GND
A22
USB_DP2_FP
A23
USB_DN2_FP
A24
GND
A25
GND
Revision – 1.6

Table 52. 50-pin Control Panel Connector

PIN
Intel order number D31980-009
7BIntel® Local Control Panel
SIGNAL NAME
B1
1_WIRE_BUS
B2
P5V
B3
P5V
B4
P5V
B5
VGA_INUSE_L
B6
GND
B7
P5V_STBY
B8
GND
B9
FAULT_LED_5VSB
B10
GND
B11
FP_SYS_FLT_LED1_R_L
B12
FP_ID_SW_L
B13
FP_ID_LED_R_L
B14
NC_IPMB_5VSB_SDA
B15
NC_IPMB_5VSB_SCL
B16
GND
B17
NIC1_ACT_LED_L
B18
NIC1_LINK_LED_R_L
B19
FP_PWR_BTN_L
B20
PWR_LED_5VSB
B21
HDD_LED_P3V3_A
B22
GND
B23
GND
B24
NIC2_ACT_LED_L
B25
NIC2_LINK_LED_R_L
69

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SR1500 - AXXMINIDIMM DDR-2 RAID Controller Cache Memory and is the answer not in the manual?

This manual is also suitable for:

Sr2500Sr2500al

Table of Contents