Other Connections; Using This Unit For Tv Audio; Audio Input Settings From Tvs (Tv Input); Connecting Auxiliary Components - Pioneer LX01 Operating Instructions Manual

Other connections

08
Chapter 8
Other connections
Important
• When making or changing connections on the side
panel of this unit, be sure to switch power off and
disconnect the power cord from the wall socket.
After completing all connections, connect the power
cord to the wall socket.
SYSTEM
• Press to set the remote control to receiver
CONTROL
control mode in order to operate the receiver
subwoofer (make sure that the LCD displays the
SYSTEM screen, as shown below).

Using this unit for TV audio

To listen to audio from a TV, connect the TV's audio cable
to one of the inputs on this unit.
Receiver subwoofer
IN 1
OPTICAL
DIGITAL
From digital audio
output (optical)
40
En
SYSTEM
ADV. F.S.
SURR
SURR SURR
Side panel
ANTENNA
L
AM LOOP
IN 2
R
ANALOG
AUDIO IN
or
From Audio output
TV
• Connect the audio output jacks on your TV to the
audio input jacks on the receiver subwoofer.
• You can connect by either a digital or analog audio
cable. Select only one method to make connections.
• To use the HDMI Control function when you are
connected to a supported Pioneer Flat Screen TV, you
must connect via HDMI.
• When digital connections are used, it may be
necessary to adjust the digital audio output settings
on the TV. For details, consult the operating
instructions for your TV.

Audio input settings from TVs (TV Input)

To listen to audio from a Flat Screen TV on this device, you
will need to connect an audio cable other than an HDMI
cable. From this menu, set the audio input to that which
you would like to connect. Press TV on the remote
control to switch this unit to the input source selected
here. This setting is changed to the selected input and
the audio from the Flat Screen TV is output from this
device.
Select from inputs Digital 1, Digital 2 and Analog.
1 Press SETUP.
SETUP
ENTER
2 Select 'System Setup' then press ENTER.
ENTER
3 Select 'TV Input', then press ENTER.
ENTER
4 Adjust the setting then press ENTER to
confirm.

Connecting auxiliary components

You can connect both analog and digital external audio
sources to this system. Digital audio sources include
digital satellite receivers, CD recorders, etc.
We recommend using an HDMI cable to connect
sources that have HDMI terminals. For more information
see Connecting using HDMI on page 42.