Pioneer LX01 Operating Instructions Manual page 154

The Initial Setup menu
15
Setting
Analog Tuner
Auto Channel Setting Auto Scan
Manual CH Setting
Channel Swapping
Video In/Out
Input Colour System
• Input Colour System cannot be set when the recorder is in D.TV mode.
• See also About the input colour system on page 161 for more information on this setting.
AV1 Out
• If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnect
using the supplied video cable, or reset the recorder (see Resetting the recorder on page 175).
• When the HDMI signal is output, the AV1 Out outputs the composite video signal even when it is set to RGB.
154
En
Options Explanation
Select your country and then wait for the recorder to auto tune into channels
in your area. After auto scan has finished, the channel mapping screen
appears showing which channels have been assigned to which programme
numbers. You can skip unwanted channels using the Manual CH Setting
option below.
Press HOME MENU to exit the channel mapping screen.
Download from TV If your TV supports this feature you can download all the channels that your
TV is tuned to via the SCART input. Select your country and then wait for the
download to complete. After the download is complete, the channel
mapping screen appears, as above.
See also the operating instructions that came with your TV for more
information.
Next Screen Proceed to the next screen if you need to adjust any of the settings made by
auto tuning. Select your country, then proceed to the manual channel
setting screen:
• Change channel presets using the CH +/– buttons (LCD page 2).
• To skip the displayed channel (because there is no station assigned to that
channel), change the Skip setting to On.
• Set the CH SYSTEM setting to match the channel system of your country
or region.
• Set the CHANNEL setting to the channel you want to assign to the current
channel preset.
• To manually fine tune the channel, change the AFT setting to Off then
adjust the Level setting.
• Set the Sound System setting to match the sound system of your region.
• The Name field allows you to input a name of up to five characters for the
current channel preset.
• If the currently selected channel is scrambled requiring a decoder
connected to the AV2 (INPUT 1/DECODER), set the Decoder setting to On.
Next Screen Proceed to the next screen to swap channel assignments of different presets
so that you can group together presets that naturally go together. Select two
presets to swap then press ENTER.
Next Screen Proceed to the next screen to set the input colour system for the external
input and the built-in TV tuner. Use the
2) to change the preset or external input. On the default Auto setting the
recorder can generally correctly detect whether the input signal is PAL,
SECAM, 3.58 NTSC or PAL-60, but in some cases you may have to set it
manually if the picture is displayed incorrectly.
Video • Sets the AV1 (RGB)-TV SCART output to standard composite video
(compatible with all TVs).
S-Video Sets the AV1 (RGB)-TV SCART output to S-Video. Recommended if you are
using a long SCART cable.
RGB Sets the AV1 (RGB)-TV SCART output to RGB. Good quality but check your
TV for compatibility. Note that on this setting signals from the built-in tuner
and from external input is not output when the recorder is in TV mode.
CH +/–
or INPUT buttons (LCD page