Pioneer LX01 Operating Instructions Manual page 28

Before you start
04
1 Connect the microphone to the MCACC SETUP
MIC jack on back of the display unit.
2 Place the microphone at your normal listening
position.
Place it about ear height, and make sure it is level by
using a table or chair.
Make sure there are no obstacles between the speakers
and the microphone.
ON
3 If the receiver subwoofer is off, press
SYSTEM ON to turn the power on.
SYSTEM
4 Press SYSTEM CONTROL to set the remote
CONTROL
control to receiver control mode.
Make sure that the LCD displays the SYSTEM screen, as
shown below.
Note
1 • If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles blocking the
speakers from the microphone) the final settings may be incorrect. Check for household appliances (air conditioner, fridge, fan, etc.), that may
be affecting the environment and switch them off if necessary.
• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during Auto MCACC setup.
2 If this doesn't work, press MCACC, turn off the power, and check the problem indicated by the Error message, then try the Auto MCACC setup
again.
3 If Complete doesn't appear, it is likely an error occurred during the setup. Please check all connections and try again.
4 See Listening with MCACC Effect on page 34 to switch on/off MCACC Effect.
28
En
DISPLAY UNIT
iPod
MCACC
SYSTEM
F.AUDIO
SETUP MIC
SYSTEM
ADV. F.S.
SURR
SURR SURR
MCACC
5 Press MCACC.
Try to be as quiet as possible after pressing MCACC. The
volume increases automatically and the system outputs
a series of test tones.
• To cancel Auto MCACC setup before it has finished,
press MCACC. The unit will continue to use the
previous settings.
• If the ambient noise level is too high, Noisy! blinks in
the display for five seconds. To exit and check the
1
noise levels , press MCACC, or to try again, press
ENTER when Retry shows in the display.
• If you see an Error MIC! or Error Speaker! message
in the display, there may be a problem with your mic
or the speaker connections. To try again, press
2
ENTER .
When the MCACC setup is complete, the volume level
returns to normal, Complete
MCACC Effect is activated.
• Be sure to disconnect the microphone from this unit
upon completion of the Auto MCACC setup.
3
shows in the display, and
4