Pioneer LX01 Operating Instructions Manual page 115

Playing and recording from a DV camcorder
ENTER
5 Select 'Record to Hard Disk Drive' or
'Record to DVD'.
6 Find the place on the camcorder tape that you
want to start recording from.
For best results, pause playback at the point from which
you want to record.
• Depending on your camcorder, you can use this
recorder's remote to control the camcorder using the
 ,  ,  ,  ,  ,  and  buttons (LCD page 1).
ENTER
7 Select 'Start Rec'.
Stop
1.02.22
Control with these
buttons
• You can pause or stop the recording by selecting
Pause Rec or Stop Rec from the on-screen display.
You cannot control the camcorder from this remote
control during recording.
• If you restart recording after stopping the camcorder,
the first few seconds of the camcorder tape will not be
recorded. Use the pause button on your camcorder
instead and recording will start immediately.
• HDD, DVD (VR Mode) and DVD-RAM only: A chapter
marker is inserted every time there is a break in the
timecode on the DV tape. This happens when the
recording is stopped or paused then restarted, for
example.
• If you don't want to see the DV recording screen
during recording, press DISPLAY to hide it (press
again to display).
• While recording, you cannot exit the DV recording
screen using the HOME MENU or RETURN button.
DV Auto Copy
DV Auto Copy allows you to make an exact copy of the
contents of a DV source to the HDD or a DVD.
1
front panel DV IN jack.
Also, set the camcorder to VTR mode.
2
3
audio input is setup as you require.
See DV Input on page 155 for more on this.
Stop
Start Rec
Pause Rec
4
Stop Rec
Home Menu.
HDD SP (2h00m/DVD)
Rem. 32h45m
5
'Record to DVD'.
The DV tape is rewound to the beginning. Once it is
rewound, the DV tape is played from the beginning and
copied to either the HDD or a DVD.
Make sure your DV camcorder is connected to the
REC
MODE
(LCD page 1) Set the recording quality.
• See Setting the picture quality/recording time on
page 95 for detailed information.
From the Initial Setup menu, check that the DV
• Check also that the Audio In settings for External
Audio and Bilingual Recording are as you want
them (see Audio In on page 155).
HOME
MENU
Select 'DV', then 'DV Auto Copy' from the
SETUP
• DV recording only works when the DV camcorder is
in VTR mode with a tape loaded.
ENTER
Select 'Record to Hard Disk Drive' or
• If there is a gap of two minutes or more between
recorded contents, the copying process is
automatically stopped.
• Once copying is finished, the DV tape is automatically
rewound.
• To cancel the copying process, press STOP REC (LCD
page 1) for more than three seconds.
08
115
En