Transport And Navigation Controls - DigiDesign C24 Manual

Transport and Navigation
Controls
Transport Mode Switches
Audition
switch
Mark In
Pre-Roll
switch
Loop Playback
Dyn Trans
switch
Transport Mode switches
Audition Switch
The Audition switch toggles Audition mode on
and off. When Audition mode is on, this switch
lights.
In Audition mode, you can listen to either the
start or end of a selection, with or without pre-
roll or post-roll, by pressing the following
switches:
54 C|24 Guide
Online
RTZ/E
switch
switch
Trans=
switch
Post-Roll
switch
switch
Mark Out
switch
QuickPunch
switch
switch
Loop Record
switch
Pre-Roll Switch Plays audio starting at the pre-
roll point up to the beginning of the selection.
Mark In Switch Plays audio starting at the selec-
tion start through the length of the post-roll
amount.
Mark Out Switch Plays audio back-timed from
the selection end by the pre-roll amount.
Post-Roll Switch Plays audio starting at the end
of a selection through the post-roll amount.
Return to Zero/Go To End Switch
The Return to Zero/Go To End switch locates the
cursor to the beginning or the end of the ses-
sion. See "Navigating with the Transport" on
page 99.
Transport Master Switch
The Transport Master (Transport =) switch cy-
cles the Transport Master through the available
options, which can include Pro Tools, Machine,
MMC, or Remote. The Transport Equals switch
lights when the Transport Master is set to Ma-
chine, MMC, or Remote.
Online Switch
The Online switch toggles the Pro Tools trans-
port online status when triggering playback
from an external source. The Online switch
flashes when the transport is waiting for sync,
and lights to indicate that the transport is on-
line.
Pre-Roll and Post-Roll Switches
The Pre-Roll and Post-Roll switches toggle the
enable status of pre-roll and post-roll in the
Pro Tools transport. The Pre-Roll and Post-Roll
switches light to indicate they are enabled.