DigiDesign C24 Manual page 56

ChanWn (Channel Window Display) Determines
whether displaying plug-in or send parameters
opens the corresponding plug-in or send win-
dow on-screen in Pro Tools.
When this preference is set to "Yes," the on-
screen display of plug-in and send windows
changes to reflect the state of the control
surface.
When this preference is set to "No," the on-
screen display of plug-in and send windows does
not change to reflect the state of the control
surface.
2KbPan (Two-Knob Panning) (Pro Tools HD Only)
Toggles linking of front and rear pan controls in
surround panner windows to facilitate left-right
motion in the surround field.
Actions
(Pro Tools HD Only)
Prview (Preview) Puts Pro Tools in Preview
mode.
PchPrv (Punch Preview) Executes the Punch Pre-
view command.
SusPrv (Preview Suspend) Suspends Preview
mode.
Captre (Capture) Executes the Capture com-
mand.
PchCap (Punch Capture) Executes the Punch
Capture command.
Join Executes the Join command.
48 C|24 Guide
Automation Preferences
(Pro Tools HD Only)
AutoJn (Auto Join) Sets tracks in Latch mode to
automatically resume writing of automation af-
ter the transport is stopped and started again
during an automation pass.
LchStp (Allow Latch Prime in Stop) Toggles the
Allow Latch Prime in Stop preference, which al-
lows tracks in Latch mode to be primed for writ-
ing automation while the transport is stopped.
ColVCA (Coalesce when Removing Slaves from
VCA Group) Toggles the preference that auto-
matically coalesces automation to slave track
when they are removed from a VCA-controlled
group.
ColTrm (Coalesce Trim Automation) Sets the pref-
erence that determines when Trim automation
is coalesced. The preference settings are as fol-
lows:
• EveryP: After Every Pass
• OnExit: On Exiting Trim Mode
• Manual: Manually