Assign Mode - DigiDesign C24 Manual

Expanded Pan/Expanded Send View
• Faders control Send parameters.
• Rotary encoders are disabled.
• Encoder switches toggle/cycle through
stepped parameters.
Plug-in Flip Mode
When C|24 is in Parameter view, Flip mode
transfers the control assignments as follows:
• Faders control plug-in parameters.
• Rotary encoders are disabled.
• Encoder switches toggle/cycle through
stepped parameters.
Mic Pre Flip Mode
Flip mode transfers PRE control assignments to
the faders and disables the encoders, as follows:
Mic Pre Console View
• Faders control PRE gain.
Mic Pre Expanded View
• Fader under "Gain" controls PRE gain.
• Fader under "Source" toggles the PRE input
source.
• Fader under "Impedance" controls the Im-
pedance setting.

Assign Mode

You can assign Inputs, Outputs, Inserts, or Sends
from C|24 using Assign mode.
When in Assign mode, an arrow (">") appears to
the left of pathnames or plug-in names in the
LCD displays to indicate the current assign-
ment. The arrow disappears to when an uncon-
firmed change is displayed.
When navigating in Assign mode, you can move
up a level by holding the Command/Ctrl switch
and pressing the encoder switch for the control
that you are assigning.
See "Assigning Pro Tools Paths" on page 91.
You can enter Assign mode while in Flip
mode. In Flip mode, move the faders (in-
stead of the encoders) to scroll through lists
in Assign mode.
Chapter 8: Operating Views and Modes 87