DigiDesign C24 Manual page 125

Mic Pre Clip Hold
You can set the Clip Hold time for the C|24
built-in mic/line/DI preamplifiers.
To set the Clip Hold time:
Press the Utility switch.
1
Press the encoder switch that corresponds to
2
"Preferences."
Press the encoder switch that corresponds to
3
"Analog."
Press the encoder switch that corresponds to
4
one of the following:
• No Hold
• 3 Sec Hold
• Infinite Hold
When you are finished, press the encoder
5
switch that corresponds to "Save."
Press the Exit switch to exit Utility mode.
6
Footswitch Function and Polarity
You can set the function and polarity for the
two Footswitch connectors on C|24.
To set Footswitch function:
Press the Utility switch.
1
Press the encoder switch that corresponds to
2
"Preferences."
Press the encoder switch that corresponds to
3
"Footswitch."
For each Footswitch (A and B), press the en-
4
coder switch that corresponds to any of the
following:
• Play: Starts and stops the Pro Tools Trans-
port.
• Record: Arms the Transport for recording
or punches in and out of Record.
• Talkback: Toggles Talkback On and Off.
When you are finished, press the encoder
5
switch that corresponds to "Save."
Press the Exit switch to exit Utility mode.
6
To set Footswitch polarity:
Press the Utility switch.
1
Press the encoder switch that corresponds to
2
"Preferences."
Press the encoder switch that corresponds to
3
"Footswitch."
Press the encoder switch under "FS A Polarity"
4
(Footswitch A) or "FS B Polarity" (Footswitch B)
to toggle polarity between "Normal" and "In-
verted."
When you are finished, press the encoder
5
switch that corresponds to "Save."
Press the Exit switch to exit Utility mode.
6
Appendix B: Utility Mode 117