Saddle Stitcher Unit Of The Booklet Finisher-A1 (Optional) - Canon C9075 PRO Operating Manual

8
Close the front cover of the finisher .
2
When closing the front cover of the finisher, be careful not to get your fingers caught, as this may result in personal injury .

Saddle Stitcher Unit of the Booklet Finisher-A1 (Optional)

If a staple jam occurs inside the saddle stitcher unit of the Booklet Finisher-A1, a screen prompting you to remove the jammed
staples appears on the touch panel display. Check the location of the staple jam, and follow the procedure described below, and
the procedure that appears on the touch panel display, to remove any jammed staples.
•
Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to replace a staple
cartridge, discard the punch waste, discard the trim waste, or clear paper or staple jams, prints may still be output if other optional units are
operating normally, and are not involved in the paper or staple jam removal procedure.
•
Before clearing the staple jam, remove all output sheets from the booklet tray.
•
This procedure is only required when the Booklet Finisher-A1 is attached to the machine.
•
If a paper jam occurs at the same time as a staple jam, remove the jammed paper before removing the jammed staples.
1
Open the front cover of the finisher .
2-100
Clearing Staple Jams