Setting Up A Wi-Fi Connection; Using Mobile Broadband With Gps; Enabling Mobile Broadband With Gps - Motion Computing C5t User Manual

N : Wireless cards consume battery power. To reduce power consumption when running on
OTE
battery power and when Wi-Fi is not being used, disable Wi-Fi in the Motion Dashboard.
To enable or disable Wi-Fi:
1. Open the Motion Dashboard to the Wireless panel
2. Select or clear the Enable Internal 802.11 Wireless check box.

Setting up a Wi-Fi connection

Follow these steps to create a Wi-Fi connection.
To set up a Wi-Fi connection:
1. Open the Motion Dashboard to the Wireless panel
2. Ensure that Enable Internal 802.11 Wireless is selected.
3. Tap the Properties button.
4. In the Network Connections center, tap the wireless network connection.
5. Tap Connect To, then select a network.
If you are connecting to a secure network, you may need to enter authentication
information. If you are connecting to an unsecured network, you may be prompted to
select whether to connect to the unsecured network or connect to a different network.

Using Mobile Broadband with GPS

Your Tablet PC may be equipped with an optional embedded Mobile Broadband with GPS
module. Use the information in this section to enable Mobile Broadband and the Mobile
Broadband GPS receiver. Mobile Broadband access requires an account with a Mobile
Broadband network carrier. To use the GPS receiver, you do not need a network connection
or an account with a Mobile Broadband network carrier.
WARNING:
air. Failure to disable the wireless device on the tablet while traveling by air can cause
communication problems with aircraft instruments.

Enabling Mobile Broadband with GPS

Before you can establish a Mobile Broadband connection or use the Mobile Broadband GPS
receiver, you must enable Mobile Broadband with GPS in Motion Dashboard.
Chapter 2 Using your C5t/F5t
FAA regulations require that you disable any wireless device when traveling by
(page 18).
(page 18).

Using Mobile Broadband with GPS 47