Using Wi-Fi (802.11A/G/N); Enabling Or Disabling Wi-Fi; Setting Up A Wi-Fi Connection - Motion Computing J3400 User Manual

Using Wi-Fi (802.11a/g/n)

Use the information in this section to set up a Wi-Fi connection. Wireless access requires an
802.11a, 802.11g, or 802.11n access point. Internet access requires a working Internet
connection.
DANGER:
by air. Failure to disable the wireless connection on the Tablet PC while traveling by air can
cause communications problems with aircraft instruments.

Enabling or disabling Wi-Fi

Before you can establish a Wi-Fi connection, you must enable the Wi-Fi adapter. You can
enable the Wi-Fi adapter using Motion Dashboard.
To enable or disable Wi-Fi
1. Open the Motion Dashboard to the Wireless panel (page 26).
2. Select or clear the Enable 802.11 Internal Wireless check box.

Setting up a Wi-Fi connection

Use this procedure to create a Wi-Fi connection.
To set up a Wi-Fi connection
1. Open the Motion Dashboard to the Wireless panel (page 26).
2. Ensure that Enable Internal 802.11 Wireless is selected.
3. Tap the Properties button.
4. In the Network Connections center, tap the wireless network connection.
5. Tap Connect To, then select a network.
Note: If you are connecting to a secure network, you may need to enter authentication
information.
For more information about Wi-Fi, see "Wi-Fi (802.11a/g/n wireless)" on page 20.
58 Chapter 3
FAA regulations require that you disable any wireless connection when traveling
Using your Tablet PC