Flex Cable Replacement - TransAct EPIC 950 Tech Support Reference Manual

Flex Cable Replacement
Installation:
When installing the cable into the Outer Chassis, make the
rear connection first. Then create a loop in the cable so that it
can be easily slipped over the clip (A) closest to the connector,
then repeat for remaining clips. Release the sliding connector
board's latches by lifting up on the two levers and push the
board towards the rear to allow enough slack to mate the front
connection. Now mate the front connection to the sliding board
and pull the sliding board forward until it is firmly latched.
Warning: If reinstalling a used cable, care must be taken to
insure that the cable's bow protrudes in the direction as shown
in figure 2 and when installed, it should look like (C).
Description: TRANSACT Part Number:
Flex Cable 98-06499L
B A
C
12