NetComm NB304N User Manual page 22

NETCOMM GATEWAY™ SERIES – NB304N – ADSL2+ Wireless N300 Modem Router
In the case of a PPPoE connection, the following options are available:
PARAMETER
PPP Username and Password
PPPoE Service Name
Authentication Method
MTU
Enable NAT
Enable Fullcone NAT
Dial on Demand
PPP IP Extension
Static IPv4 Address
Enable IPv6
Enable IGMP Multicast Proxy
Enable MLD Multicast Proxy
Click Next once the connection configuration details have been entered.
(a) Select the Default Gateway Interface to use for the connection and click Next
(b) Select the DNS Server Interface to use for the connection and click Next
(c) Review the configured functions of the connection and click Save/Apply to save the new WAN Service
connection.
YML304X
www.netcomm.com.au
The username and password required to access the service
A name to identify the configured service
Select the authentication method in use on the service
Set the Maximum Transmit Unit (MTU) size for the connection
Select to enable or disable Network Address Translation (NAT) for this connection
Select to enable Fullcone NAT on the connection.
Select to enable dial on demand mode. Enter the idle time to wait before disconnecting the service.
Select to enable PPP IP Extension on the connection
Enter a static IP Address to utilise with the connection
Select to enable IPv6 support for the connection. This enables the NB304N to Request Prefix Delegation and
request an IPv6 Address.
Enable IGMP Proxy mode on the connection. This is commonly used for IPTV.
Enable MLD Proxy mode. This is the IPv6 equivalent of IGMP proxy mode.
DEFINITION
NetComm NB304N – ADSL2+ Wireless N300 Modem
22