Epson Stylus Pro 3800 User Manual page 108

EPSON Stylus Pro 3800
HEAD ALIGNMENT
This menu contains the following items.
AUTO
You can correct any head misalignment automatically to obtain optimum printing results. If
you use Epson special media, select AUTO, and then select the paper.
MANUAL
You can correct any head misalignment manually to obtain optimum printing results. It you
use non-Epson special media, select MANUAL, and then select the paper thickness in the
range of 0.1 to 0.4 mm. For details, see "Aligning the print head" on page 110.
NETWORK SETUP
This menu contains the following items. For detailed information about network settings,
see the Administrator's Guide.
NETWORK SETUP
You can configure the network setting of the printer. The following items appear only when
ENABLE is selected.
IP ADDRESS SETTING
You can select the method to set the IP address to the printer. When AUTO or PING is
selected, IP, SM, DG SETTING is not displayed. Select PANEL to set these addresses using
the printer's control panel.
Choose PANEL when setting the IP address, subnet mask, and default gateway using the
printer's control panel.
Choose AUTO when getting the IP address from a DHCP server. The IP address is
automatically obtained from the DHCP server whenever the printer is reset or turned on.
Choose PING when setting the IP address using the arp/ping command. The network
interface uses the IP address set by the arp/ping command. The settings become available
when the printer is reset or turned off and then back on.
IP, SM, DG SETTING
You can set the IP address, Subnet Mask, and Default Gateway to the printer.
User's Guide
108
The Control Panel