Fisher & Paykel DishDrawer DS605 Diagnostic Service Manual page 26

599464
F6 Lid Motors Ran But Did Not Reach Stall Current
Lid actuators ran but did not reach stall current.
The product will pause the wash program, log the fault and report to the user.
PRIMARY ACTION
- Check that the lid actuators are properly connected to the yokes and the
slide mounting bracket.
- Check that the yokes are clipped into the lid.
- Run the lid actuators in diagnostics.
SECONDARY ACTION
- Replace the lid actuators.
- Replace the controller.
F7 No Lid Motor Current Detected
No lid actuator current detected.
The product will abort the wash program, log the fault and report to the user.
PRIMARY ACTION
- Check that the lid actuator connectors are properly fitted.
SECONDARY ACTION
- Check that the controller is receiving power (use diagnostics to run the wash
or drain pump).
- If not, check the harnesses.
TERTIARY ACTION
- Replace the PCB mains filter.
- Replace the controller.
26