Fisher & Paykel DishDrawer DS605 Diagnostic Service Manual page 19

Fault LED
Code Display
F2 Delicate
LED.
F3 Delicate
and Rinse
LEDs.
F4 Fast LED.
F5 Fast and
Rinse
LEDs.
F6
Fast and
Delicate
LEDs.
Fault
The controller • Foreign object has jammed the
has not
sensed the
• The rotor has failed.
motor rotating.
• Hall sensor connector or wiring
• The hall sensor has failed.
• Motor stator winding or
• The electronic controller has
• PCB mains filter has failed.
The water • The incoming water is greater
temperature
has been
• The element has failed closed
sensed as
greater than
• The temperature sensor on the
85 C (185 F).
° °
• The electronic controller has
No • The element is not connected.
temperature
• The element has failed open
increase has
been sensed
• The temperature sensor has
for about 4
hours while
• The electronic controller has
the element is
on.
• Lid jammed up or down.
Lid motor
• The electronic controller has
current too
high during
start.
• Lid actuator off yoke or slide.
Lid motors ran
• Yoke off lid.
but did not
• Faulty lid actuator.
reach stall
current.
19
Possible Causes
rotor.
fault at hall sensor or
controller.
connection open circuit.
failed.
than 85 C (185 F).
° °
circuit.
heater plate has failed.
failed.
circuit.
failed.
failed.
failed.
599464