Fisher & Paykel DishDrawer DS605 Diagnostic Service Manual page 10

599464
As mentioned on the previous page, the LCD display and touch switch panel
LEDs are illuminated to correspond to a particular hardware device. The
following table details the display order of the test.
Norm Fast
LCD LED LED
bL Off Off
Er Off Off
Ld Off Off
On
dd Off
FU Off On
P1 Off On
P2 Off On
rd On Off
dF On Off
LE On Off
C1 On Off
C2 On On
C3 On On
°C On On
°E On On
(C3 is used in the Factory to empty the Water Softener before the Product is
packed.)
WARNING: In diagnostic mode there is no component protection. Therefore
take care when running individual components not to overload them. It is
advisable to avoid turning the element on without placing some water in the
tub first.
NB : No fault codes will come up while in diagnostics mode.
Tub Home Sensor Test: At any time during HO test mode, the Keylock
symbol on the LCD display (Keylock LED on integrated badge) indicates the
tub position. On = Closed, Off = Open.
Deli Rinse
LED LED
Off On Backlight
On
Off Element Relay
On On
Lid Motors (will run for 10 seconds)
Off Off Detergent Diverter Valve
Off On Fill Water Valve
On Off Motor Wash direction (2300-2850
rpm)
On On Motor Drain direction (4200 rpm)
Off Off Rinse Aid Dispenser (dispenses
current setting)
Off On Drying fan
On Off Rinse Aid LED
On On Water Softener Diverter Valve
Off Off Water Softener Brine Pump
Off On Water Softener Brine Valve
On Off Displays current water temperature.
On On Displays controller rail voltage
10
Hardware Output