SERVICE WORK ON THE CHASSIS
Adjusting the play of the steering head bearing
11.14
Greasing the steering head bearing
11.15
Removing the start number plate
11.16
Installing the start number plate
11.17
x
–
Raise the motorcycle with the lift stand. (
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
Guideline
Screw, top triple clamp
303536-10
–
Mount and tighten screw
Guideline
Screw, top steering stem
–
Check the play of the steering head bearing. (
x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
–
Remove screw
–
Remove screw
101278-10
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Ensure that the holding lugs engage in the fender.
–
Position the brake line. Position the clamp and mount and tighten screw
101278-11
. Remove screw
.
.
M20x1.5
.
M8
.
M8
(
p. 40)
x
(
p. 41)
x
and take off the clamp.
. Take off the start number plate.
M6
p. 37)
12 Nm (8.9 lbf ft)
17 Nm
(12.5 lbf ft)
17 Nm
Loctite
®
243™
(12.5 lbf ft)
p. 42)
.
10 Nm (7.4 lbf ft)
43
.